Beta version info:
Using beta-version 6 or earlier is not recommended.

Version 7-9 is all fine.

Version 7
- Fixed the brief failsafe that could occur.

Version 8
- PPM out from the receiver is the same as PPM from the transmitter (before this, it was fixed to 12 channels out)
- Servos was briefly centered on initial link

Version 9
- A few seconds delay when entering bind removed

Version 10
U-ppm and headtracker enabled

Version 11
- In servo test-mode, low power = micro-power and high-power = normal high power
- In the menu, holding the button for a long time will allow to select default ID. 
No changes on RX

Alternative versions:
Rx_v11_12CH_PWM:
Replaces PPM-output on channel 12 with servo-output. 

Tx_v11_3random_ID:
The random-function when setting new ID only cycles between 3 different ID's.
This can be used if 2 transmitters are used with same RX. 

Rx_V11_1280MHz_optimized and Tx_V11_1280MHz_optimized (MUST be used together)
This version ensures no use of frequencies that will give harmonic noise close to 1280MHz. 